Koden MDC-2000BB Series, Operation Manual

Page: 95 / 112

MDC-2000BB Series Chapter 5 Equipment
0093120012-01 5-33
Output Sentence
The TTM and TLL sentences can be transmitted.
Outputting is performed in NMEA0183 Ver. 2.0.
Sentence Information
TTM* Target Information
TLL** Target Position
* To output the TTM sentence, install the ATA board (optional) and
heading bearing data and ship’s speed data are required.
** To output the TLL sentence, the latitude and longitude data and the bearing signal data are
required.
5.8 Junction Box (JB-35) Installation
When JB-35 is connected, NMEA0183 port can be increased from one to three.
* Ensure that not to connect any cable to NC pin of SLAVE1 (J5), SLAVE 2 (OP1) and SLAVE3 (OP2).
* JB-35 should be removed when renewing the system program.
CW-376-5M
To J5 of Processor unit
SLAVE1
SLAVE3
MASTER
SLAVE2
S1
ON OFF
1
2 3
4 5
6
7 8
ON (No.1 only)
J5
OP1
OP2
JB-35
NC*
(TX-)OUT-B
(TX+)OUT-A
(RX-)IN-B
(RX+)IN-A
GND
Green
Black
Orange
Red
White
Blue+Shield
+12V
(TX-)OUT-B
(TX+)OUT-A
(RX-)IN-B
(RX+)IN-A
GND
NC*
(TX-)OUT-B
(TX+)OUT-A
(RX-)IN-B
(RX+)IN-A
GND
NC*
(TX-)OUT-B
(TX+)OUT-A
(RX-)IN-B
(RX+)IN-A
GND