Koden KDS-6000BB, Installation Manual

Page: 62 / 72

Chapter 3 Maintenance KDS-6000BB
3-2 0092660002-06
3.2.2 Hull unit
As for the inspection of the TD tank and the TD shaft, inspect the appearance and the hoisting
and lowering operation. When the mooring period becomes long, shells and oil may adhere to
the inside of the TD tank. Pay attention that some adherence may cause abnormal operation.
3.3 Fuse replacement
Fuse blows out when such as a trouble occurs inside at too high input voltage or over current.
The fuse is located on the back panel of the Processor unit and Hull unit. Please replace with
the fuse listed in the list of standard components.
3.4 Diagnostics of troubles
In this section, simple procedures to find out troubles are mentioned to locate the troubles on
boat.
3.4.1 Necessary information for requesting repair
Please inform of the following points:
(1) Name of ship, and telephone number, if a satellite communication system is equipped.
(2) Failed equipment name and type name
(3) Equipment serial number
(4)
“Version number. of system software” displayed on “Title screen”
(5) Next calling port and name of sales agent, telephone number, Fax number, e-mail
address, etc.
(6) Details of failure (as much as possible) and failure diagnostics results on board, as well as
operation conducted, in particular, until the failure or when the failure occurred.
Use the specified fuse. If you use a fuse other than
specified one, it may cause a serious accident.
Warning: