Koden KDS-6000BB, Installation Manual

Page: 36 / 72

Chapter 1 Installation KDS-6000BB
1-16 0092660002-06
3) Attaching the Transducer unit to the Hull unit.

Apply grease to the bearing of the Flange and the inside of the waterproof nut.

Loosening the waterproof nut and thread the TD shaft through the Flange bearing,
and thread the damper. Mount them to the Joint arm matching the bow direction.

Ensure that the TD shaft end projects 21mm from the Joint arm surface.
In case of the length of the TD tank other than 1230mm long.

In the use case of other TD tank, ensure the lowest part of the Transducer unit
is at least 50mm above the lowest part of the TD tank.

To prevent slip-out of the TD shaft, fasten the attached Fixing collar using Cap bolt
(4pcs).
Fig. 1.18 Assembling Hull unit - 3
The waterproof nut and fixing nuts
are delivered with attached to the
Flange.
Apply grease to the contact surface
with a TD shaft.
21mm
Joint arm
Fixing collar
Damper
Cap bolt M4 x 10
When the TD shaft
is attached to the
Joint arm, ensure
the bow marks are
aligned.
For instructions on fastening
method of the waterproof nut,
see next page.