Koden KDS-6000BB, Installation Manual

Page: 34 / 72

Chapter 1 Installation KDS-6000BB
1-14 0092660002-06
(3) Assembling the TD shaft and the Transducer unit
1) Fasten the TD shaft to the Transducer unit. At this time, be sure not to damage the TD
shaft thread and not to twist the cable.

Remove stains and grease fully at the threaded part of the Transducer unit and the
TD shaft, and apply the attached waterproof sealer (Bath Cork) to the threaded part
only.

Fasten the TD shaft to the Transducer unit. As there is a packing at the Transducer
unit side, fasten as far as the packing will work to the point where no slackness will
occur. Be careful that excessive fastening strength causes breaking of the packing.
Use the attached 4 pieces of Cap bolt to prevent loose bolt, and cover the Cap bolt
with waterproof sealing agent to prevent electric corrosion.

After fastening of the TD shaft to the Transducer unit, please mark up the Bow mark
at the top end of the TD shaft.
Fig. 1.16 Assembling Hull unit - 1
キャップボルトを
防水シール剤で覆う
４ヶ所
Covering 4 Cap bolt with
waterproof sealing agent.
(at 4 point)
When the Transducer unit and the TD shaft
are assembled or dismantled, be sure to hold
on the metal portion of the Transducer unit
and turn the TD shaft.
If the Transducer unit is turned to be
dismantled, the Transducer unit or cables
may be damaged.
Do not apply or fill up the inside of the TD
shaft with waterproof sealing agent. If the
cable of the Transducer unit is bonded,
there may be damages on the Transducer
unit or the cable during dismantling for
maintenance works.
Caution
Caution
Don
’t apply waterproof
sealing agent inside the
TD shaft.
船首マーク
（マジックで印を付ける）
ジ
ョ
イ
ン
ト
パ
イ
プ
ネジ部に
防水シール剤を塗布
サウンドーム
船
首
方
向
キャップボルト
Ｍ４×１０
４ヶ所
Bow mark
(Mark up with an oil-ink felt pen)
Bow
M4 x 10 of Cap Bolt
(at 4 points)
Threaded part
Apply waterproof
sealing agent.
(Silicon sealant)
Transducer
unit
TD shaft