Kodak X-OMAT 7000, User Manual, Page: 90 / 146

Key Operator Instructions
5– 30 16FEB01 – 7E6174
Selecting a Stand-By Mode
If no new films are fed the Processor enters the standby mode for approximately 15
seconds after the last film exits. There are 2 stand-by modes: the interval mode or the
continuous mode. The default setting is the interval mode. In the interval mode, the
Transport System and wash water turn on periodically to ensure that the Rollers are
wet. In the continuous mode, the Transport System operates continuously at a reduced
speed to ensure that the Rollers are wet. In both modes:
• the Dryer Blower and Heater turn on as required to maintain the Dryer temperature
• the wash water turns on every 8 1/2 minutes to clean the Rollers
• the Solution Heaters remain on as needed to maintain the setpoint temperature of
the solutions
1. Press GO TO SETUP.
2. Enter the 4-digit access code.
H186_8522AC
DATE
TIME/
STD
95.0 F = DEV TEMP
RETURN SETUP FIX TEMP
127.4 F = DRYER TEMP
DONE/ GO TO DISPLAY
PROCESSOR READY
H186_8523AC
4 2
REQUEST
CANCEL 3 1