Kodak X-OMAT 7000, User Manual, Page: 15 / 146

Introduction
7E6174 – 16FEB01 1– 9
Caution
• According to the European EN Safety Regulations for medical devices, direct
contact between the patients and the Multiloader is not allowed.
• If the Kodak Service Representative connected the Multiloader to the
Equipotential Busbar using the Equipotential Bonding Plug, this connection may
not be interrupted, for example, you are not allowed to pull off the cable coming
from the equipotential busbar.
• This equipment generates, uses and can radiate radio-frequency energy, and if not
installed and used in accordance with the User Guide, may cause interference to
radio communications. It has been tested and found to comply with the limits for
a Class A computing device pursuant to Subpart J of Part 15 of FCC Rules, which
are designed to provide reasonable protection against such interference when
operated in a commercial environment. Operation of this equipment in a
residential area is likely to cause interference, in which case the user, at the user’s
own expense, will be required to take whatever steps may be required to correct
the interference.
Chemical Hazards
Warning
Gloves and protective eye wear must be worn when working with the processor
chemistry, especially when mixing the chemistry.
If the processor chemicals get in the eyes, flush them thoroughly with large amounts
of water. If irritation persists, check with a doctor.
Chemistry spills outside the equipment must be cleaned up immediately. This may
result in a potential cause of falls and the chemistry can contaminate waste water and
irritate the skin, especially the eyes. If a chemical spill occurs, do the following:
1. Prevent the spilled chemistry from entering a waste water drain.
2. Clean up the spill with a moist mop or rag.
3. Dispose of cleaning materials and waste water collected during the cleanup in an
environmentally approved way.
4. Drain chemicals into provided containers and carry out disposal according the local
regulations.