Kodak X-OMAT 7000, User Manual, Page: 13 / 146

Introduction
7E6174 – 16FEB01 1– 7
Warning
• Only Kodak Service Representatives are allowed to install the Multiloader.
• Never cover the venting slots of the Multiloader.
• Do not perform repairs, or exchange internal parts yourself, call a Kodak Service
Representative.
• Do not operate the Multiloader with a damaged power cord.
• Do not use an extension cord to power the Multiloader.
• Place the power cord so it will not be tripped over or pulled.
• Connect the Multiloader mains plug to a grounded outlet.*
• After installation from Kodak Service, the mains plug must always be easily
accessible.*
• The Heater Plenum is hot. Use caution to avoid burns.
• Before placing the Processor into the Multiloader, move your hands away from the
Stop Bracket. Place both hands into the openings of the left and right latches on the
Front Cover of the Processor to avoid contact with any moving parts.
Warning: See Step 9 on Page 4– 11.
Warning
The Multiloader is not contained in a sealed cabinet. Therefore it must not be used in
locations where it can come in contact with liquids, including bodily fluids.
* Cord connection only.