Kodak DryView 8150, Service Manual, Page: 285 / 470

Section 7 -- Troubleshooting
7-33
2005 July Rev. B 7F3318
h. Select the “ScriptRunTime” tab.
•
Loading will take about 4 to 5 minutes.
•
When loading is complete, the word “Pass” is displayed in the Service WebLink window.
18. Open the FRONT DOOR.
19. Open the DRE DOOR.
20. Remove the video CD and close the DRE DOOR.
21. Insert a FILM CARTRIDGE.
22. Close the FRONT DOOR.
23. If RMS was enabled on this IMAGER, you will need to restart RMS:
a. In the Service Weblink, select “Configuration > System > Remote Monitoring”
b. Click [Modify]
c. Click [Save]
d. Click [Start Service]
24. Verify RMS registration:
•
Refer to paragraph 2-6-11 in Section 2.
•
Perform steps 1 through16 of the RMS Grouping procedure.
25. Reload the MPDB (Modality Preferences Data Base). See the procedure below.
7-2-21. Reloading the MPDB through RMS
This process is used at sites with RMS to install the MPDB update after the update has been downloaded
from ACMS.
1. Launch the RMS Main Screen and log in (https://qss.kodak.com/qss/login.jsp).
2. Under Groups, expand Remote System Managers.
3. Locate the region, area/country and hospital.
4. Click the hospital folder.
5. The devices located at the selected hospital will display on the screen.
6. Click the device SA (e.g. K8150xxx.USA.8150xxx.SA).
7. Click the Device Explorer Popup icon to display two screens.
8. Under File Transfer, click Upload .
9. Click
Local
.
10. Next to the Select File box, click Browse to locate the MPDB update file on your hard drive. The file
will be at the location where it was downloaded from ACMS. Refer to ACMS Query.
11. Select the file.
12. Click Open .
13. The file name appears in the Select File box.