Kodak DirectView CR 500 System, User Manual

Page: 106 / 236

8-8 1F1976 August 1, 2003
Maintaining Equipment and Cassettes
Replacing Erase Lamps
The part number for ordering the erase lamps is 1F9373. When you place an
order, you receive two lamps; they are replaced in pairs. In the United States
and Canada call 1-800-431-7278 to place your order. For all other locations,
contact your Kodak representative.
You can replace the erase lamps from the side of the machine without using
any tools.
NOTE: Use only Kodak Erase Lamps (PN 1F9373) in the CR 500.
CAUTION
:
The lamps contain mercury. Disposal of these components may
be regulated due to environmental considerations. For
disposal or recycling information, please contact your local
authorities or visit the Electronics Industry Alliance Web site at
http:\\www.eiae.org.
CAUTION
:
Be careful when touching internal surfaces. They may be hot!
1.
Turn off the power to the CR 500 Reader. See “Shutting Down the
System” on page 3-3 .
2.
Remove the side panel.
3.
Unplug the lamp housing assembly.
4.
Loosen and remove the thumbscrew.
5.
Slide the lamp assembly out.
6.
Change the lamps.
7.
Return the lamp assembly.
8.
Replace the thumbscrew.
9.
Plug in the lamp housing assembly.
10.
Replace the side panel.
11.
Turn on the power to the CR 500 Reader. See “Starting the System” on
page 3-1 .
CAUTION
:
If the mercury lamps should break during replacement, follow
your organization’s mercury removal plan.