SIMDOS diaphragm metering pump
Assembly and connection
KNF Flodos BA_SIMDOS_EN_02_160044.docx
Translation of original operating manual
15
Electrical connections must comply with relevant standards,
directives, regulations and industry standards.
1. Connect the mains plug cable to the socket in the pump.
2. Plug the mains plug into a correctly installed and properly
earthed mains socket.
Fig. 11: Electrical connection
The pump must be connected only to a correctly installed and
properly earthed mains socket.
Ensure that the mains plug is protected from water splashes.
CAUTION
Safety note
Always remove the mains plug
from the socket before carrying
out any work on the pump.
6.3. External drive (RC version)
1. Fit an appropriate plug on the external drive cable (RC cable)
for the control unit to be used. For pin allocations, see section
4.6, Table 10 and Fig. 1).
2. Remove protective cover from the RC plug.
3. Connect the RC cable to the pump.
Signals and load capacity (see section 4.6).
RC functions (see Chapter 8).
RC cable
