30
Operation
KNAUER
10D User Manual V7670, Version 2.3
Local Area Network (LAN)
A detector connected to a LAN is recognized by the software
and automatically receives an IP address because it is set to
Dynamic Host Configuration Protocol (DHCP) at the factory.
Prerequisite
Device has been connected to LAN.
Status display is active.
Serial interface
The user can choose between two ports:
115200: Serial port for cables with up to 2-m length
9600: Serial port for cables longer than 2 m
Prerequisite
Detector is connected to a computer.
Status display is active.
Process
Figure
Procedure
1. Keep left arrow key
pressed. Press right
arrow key until the cor-
rect display appears.
2. Let go of left arrow key.
3. Using the arrow keys,
set to LAN DHCP.
Fig. 21
Display control
Result
When setting is finished, the status display appears.
Control
LAN DHCP
Process
Figure
Procedure
1. Keep left arrow key
pressed. Press right
arrow key until the cor-
rect display appears.
2. Let go of left arrow key.
3. Using the arrow key,
select the baud rate.
Fig. 22
Display control
Result
When setting is finished, the status display appears.
9600
Control
