KM SVS2000, Installation & Operation Manual, Page: 88 / 89

84
97-1129-01 Rev. D
www.kistlermorse.com
23 Linearization
Linearize Set2 —
1In — 0 1Ot — 0
2In — 2,500 2Ot — 2,500
3In — 5,000 3Ot — 5,000
4In — 7,500 4Ot — 7,500
5In — 10,000 5Ot — 10,000
Linearize enable — OFF
24 Zero Tolrance2 — 100
30 Setpoint Menu
31-38
Relay #1 and #2,
Digital Outputs #1 through #6
value — 0
Deadband2 — 10
Hi/Lo — Lo
Track — grs
Fail-Safe — Off
Preact — 0
40 I-Output Menu
41 IOut range — 4-20mA
42 IOut: 4/0mA2 — 0
43 IOut: 20mA1, 2 — 9999
44 IOut Track — grs
45 IOut Failsafe — Lo
46 IOut enable — Off
48 Current Adjst
0mA Point — 910 cts
4mA Point — 3,600 cts
20mA Point — 14,516 cts
50 Com Menu
51 Serial Addres — 255 decimal/FF hex
52 Serial Baud — 9600
60 Sensor Menu
61 Sensor Adj ex1 — 12 v
62 resolution — 21bt
63 Sensor gain1 — 2
70 Filter Menu
71 Averaging — 1
72 DSP enable — On
73 DSP Step2 — (based on 10,000 counts)
74 DSP Qualify — 3
75 DSP Factor — 100%
80 Tracking Menu
81 rate Threshld2 — (based on ±10 uv/sec)
82 Sample Intrvl — 10 seconds
83 Zero Trak Win2 — 0
84 Drift Limit2 — (based on ±5 mv)
85 mat Trak enab — Off
90 Service Menu
91 user Access — (no code needed)
92 keyboard Lock — (no code needed)
notes:
1 Values for these parameters may have changed
as a result of Quick Config entries and/or
internal calculations based on those entries.
2 Values for these parameters are consistent with
Disp Format. For example, if Disp Format is
xxxxxx, Zero Tolrance is 100. If Disp Format
is xxxxxx00, Zero Tolrance is 10,000. If Disp
Format is xxxxx.x, Zero Tolrance is 10.0.