KM SVS2000, Installation & Operation Manual, Page: 33 / 89

29
www.kistlermorse.com
97-1129-01 Rev. D
dISplay Menu [10]
The Display Menu is used to set up the parameters that govern the display functions when in Run Mode. This
chapter provides explanations of the display parameters and detailed navigation procedures through the menu
tree.
11 dISp (dISplay) ForMaT
note: Disp Format was set by the SvS2000 based on your entries in Quick Config. In the Disp Format menu you
can change the format. However, if you change Disp Format you must also change other setup parameters. See
Modifying Disp Format and Disp Units in this chapter for details.
This menu allows you to set up the numerical format by selecting the number of digits to be displayed to the
left and right of the decimal point while in run mode. Listed below are the seven formats available (x is a place
holder and 0 is a ‘dummy’ zero):
xxxxxx xxxxx.x xxxx.xx xxx.xxx
xx.xxxx xxxxxxo xxxxxxoo
Disp Format is used with Disp Countby to provide a stable display, and to provide meaningful results consistent
with system accuracy. For example, you do not want to have the display showing weights like 1000.01 lbs if
system accuracy is +/- 20 lbs.
Follow this procedure to modify Disp Format:
1. If the SVS2000 is in Run Mode, press the ‘1’ Key, ‘1’ Key, and Enter Key to access the menu tree. The
display shows:
11 DISP FORMAT
2. Press the enter key to access this menu. The display looks like this:
FOrmAT: *xxxxxx
(Asterisk indicates the current selection.)
If the displayed menu does not have the desired format, press the Up Arrow Key to display the next
page of the menu.
Continue to press an Arrow Key until you see the desired format (there are seven pages to the Disp
Format Menu).
3. When the display shows the desired format, press the Enter Key. The display acknowledges the
selection and returns to:
11 DISP FORMAT
4. Press an Arrow Key to scroll to another menu or press the Gross or net Key to return to Run Mode.
12 dISp (dISplay) counTBy
note that Disp Countby was set by the SvS2000 based on your entries in Quick Config. In the Disp Countby
Menu you can change the countby. This menu is used to set up the display to count by increments of 1, 2, 5, 10,