KM SVS2000, Installation & Operation Manual, Page: 26 / 89

22
97-1129-01 Rev. D
www.kistlermorse.com
21. Press the enter key. The display shows:
> 0 SUPPORTS
22. Use the numeric Keys to input the number of vessel supports. Press the Enter Key. The display
acknowledges the entry.
23. The display shows:
CurrnT LIve LOAD
24. Press the enter key. The display looks like this:
> 0 lbs
If you selected kg, the display shows kg.
25. Use the numeric Keys to input the weight of material currently in the vessel. Press the Enter Key. The
display acknowledges the entry and shows:
COnFIg COmPLeTe!
Quick Config is complete. The system is mointoring the vessel contents using a calculated calibration based
on your inputs. note that Quick Config calibration does not take into account the actual structural response to
changes in load. We theoretically expect a change in load to result in a proportional change in digital counts,
but the structure’s actual response to load and interaction with piping, catwalks, a roof, discharge chutes, etc.
prevent the system from achieving the theoretically expected values. Additionally, Quick Config calibration could
be inaccurate if your estimate of the current material weight was off. When scheduling permits you to move
material into or out of the vessel, perform a live load calibration (Auto Cal) to obtain the highest accuracy.
run Mode dISplay
When Quick Config is complete, the SvS2000 automatically switches the display to run mode. In run mode, the
SVS2000 displays material weight or other indication of vessel contents. While in Run Mode, toggle between the
displays for gross weight, net weight, total weight, and relay status by pressing an Arrow Key. Pressing the Gross
key or net key causes the SvS2000 to go directly to the respective displays. The displays look like this:
GRS 12345600 lbs
nET 12345600 lbs
TOT 12345600 lbs
rLy1On rLy2OFF
If you selected kg as the unit of measure in Quick Config, the displays show kg.
note: If you set up a keyboard Lock Code, the SvS2000 will not respond to any keys if more then 3 minutes has
elapsed since the last time you pressed a key. enter the keyboard Lock Code to ‘unlock’ the keyboard.