Operating manual 17.410+411
Pos.: 20
Dateiname
Firma
Datum
Rev
BK-DH 700 x 1000 eng.doc
BRUKS-KLÖCKNER
27.02.09
00
Seite 48 von
61
- In order to check or change the belts, the belt guard must, if necessary, be re-
moved. This must only be done with the machine at a standstill and a locked out
motor. After completion of the work, the guard must be replaced immediately.
- When changing belts, the centre distance must be reduced, so that the belts slip
on easily. If the belts are forced on by rotating the sheave, damage to the belts can
occur, as well as injury to the hands; the high moment of inertia makes fast stop-
ping of the sheave by hand impossible.
8.8.2 Flat belts
Flat belts do not require maintenance.
Checks for tension are not required.
However, should the belt be removed or changed for any reason, it is important that
the belt be re-installed with the correct tension.
In order to check or change the belt, the belt guard must, of necessity, be removed.
This must only be done with the machine at a standstill and a locked-out motor. After
completion of the work, the guard must be replaced immediately.
8.9
Chain drive
Chains running in completely enclosed chain cases require new grease once a year.
At this time the case should be thoroughly cleaned and filled with new grease. To
change grease only partially is not recommended.
Chains running in open chain guards require lubrication once a day with oil applied
with oil can or brush.
Kette4.cdr
