Operating manual 17.410+411
Pos.: 20
Dateiname
Firma
Datum
Rev
BK-DH 700 x 1000 eng.doc
BRUKS-KLÖCKNER
27.02.09
00
Seite 34 von
61
- Clean out knife pocket, particularly the clamping surfaces and insert a new re-
ground knife. (For grinding and adjustment see „Inspection and Maintenance“).
- Tighten knife clamping bolts.
Start with a bolt in the center and then alternatively left and right. It is imperative
that the supplied torque wrench be used for this purpose (for required torque see
„Technical data“). Electrical or pneumatic wrenches must not be used. If the bolts
need to be replaced, a lubricant containing MoS2 must be used.
- Pull out rotor holding pin and rotate rotor to the next position by hand.
- After changing all knives the rotor holding pin is to be placed back into its holder
and the rotor to be rotated manually for control.
- After pulling out the safety bolt (if bolt skews, just gently tap the press button „hood
up“) the rotor hood is to be lowered by pressing the button „hood down“. When re-
leasing the press button while lowering the hood will remain in its respective posi-
tion.
- If the hood is completely closed it is to be locked with the rotor hood locking de-
vice.
