ENGLISH
ASSEMBLING THE BOWL LIFT STAND MIXER
|
7
To Attach Bowl
1� Turn speed control to "0" (OFF)�
2� Unplug Stand Mixer or disconnect power�
3� Place bowl lift lever in down position�
4� Fit bowl supports over locating pins�
5� Press down on back of bowl until bowl pin
snaps into spring latch�
6� Raise bowl before mixing�
7� Plug into an earthed outlet or reconnect
power�
To Remove Flat Beater, Wire Whip,
or Dough Hook
1� Turn speed control to "0" (OFF)�
2� Unplug Stand Mixer or disconnect power�
3� Press beater upward as far as possible and
turn left�
4� Pull beater from beater shaft�
5� Plug into an earthed outlet or reconnect
power�
Electrical Shock Hazard
Plug into an earthed outlet.
Do not remove earth prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these
instructions can result in death,
fire, or electrical shock.
To Remove Bowl
1� Turn speed control to "0" (OFF)�
2� Unplug Stand Mixer or disconnect
power�
3� Place bowl lift lever in down position
4� Remove flat beater, wire whip, or
dough hook�
5� Grasp bowl handle and lift straight up and
off locating pins�
To Raise Bowl
1� Rotate lever to straight-up position�
2� Bowl must always be in raised, locked
position when mixing�
To Attach Flat Beater, Wire Whip,
or Dough Hook
1� Turn speed control to "0" (OFF)�
2� Unplug Stand Mixer or disconnect
power�
3� Slip flat beater on
beater shaft and
press upward as
far as possible�
4� Turn beater to
right, hooking
beater over the pin on shaft�
5� Plug into an earthed outlet or reconnect
power�
To Lower Bowl
1� Rotate lever back and down�
ASSEMBLING THE BOWL LIFT STAND MIXER
Book 1.indb 7
5/30/2018 8:44:10 PM
