ENGLISH
USING THE KITCHENAID ATTACHMENTS
|
11
Your Stand Mixer is adjusted at the factory so the flat beater just clears the bottom of the
bowl� If, for any reason, the flat beater hits the bottom of the bowl or is too far away from
the bowl, you can correct the clearance easily�
1� Unplug Stand Mixer or disconnect power�
2� Place bowl lift lever in down position�
3� Attach flat beater�
4� Adjust so flat beater just clears bottom
surface of bowl when in lifted position
by turning screw (A) counterclockwise
to raise the bowl and clockwise to
lower the bowl� Just a slight turn is all
that is required: the screw will not
rotate more than 1/4 turn (90 degrees)
in either direction� The full range of
adjustment is 1/2 turn, or 180 degrees�
5� Place bowl lift lever in up position
to check clearance�
6� Repeat steps 4 and 5 if necessary�
Lower Bowl
Raise Bowl
A
If your Stand Mixer comes with a bowl
guard, make sure that the guard is returned
to the down position before beginning to
use the Stand Mixer� The Stand Mixer will
not run if the bowl guard is not in the proper
position�
*Included with select models� Picture may vary from product depending on model�
NOTE:
When properly adjusted, the flat
beater will not strike on the bottom or
side of the bowl� If the flat beater or the
wire whip is so close that it strikes the
bottom of the bowl, the beater or whip
may wear�
USING THE KITCHENAID ATTACHMENTS
BEATER TO BOWL CLEARANCE
USING THE BOWL GUARD
Book 1.indb 11
5/30/2018 8:44:12 PM