20
VISION 1014C INSTRUCTION MANUAL
20
GENERAL Operation
Error Chirp
When you arm the 1014, the system ignores all trigger sectors (e.g., door,
sensor, ignition, etc.) for the first 3 seconds while Status LED is lit solid.
If there is still an unsecured sector after the 3 seconds, the siren will chirp
1 time and then a 2nd time (“error chirp”) a few seconds later. (In Silent
Mode, chirps will only be produced by the internal piezo siren of the Alarm
Unit.) Vehicle lights will flash twice, if so installed. If the unsecured sec
-
tor is later secured (i.e., the opened door was later closed), the system will
silently re-enable that sector 5 seconds later.
(Also see “Exit Delay Time
Selection” at the bottom of page 26.)
DISARMING
NORMAL METHOD
This method is the typical way to disarm the 1014, with
confirmation chirps active.
Press Button-1 on the trans-
mitter while the system is armed. The doors will then un-
lock and hazard lights will flash 3 times (if so installed). The
siren will chirp 3 times. The system is now disarmed, and
you may enter the vehicle without triggering the siren.
0USHå"UTTON
NO-CHIRP METHOD
This method of disarming is identical to the
“Normal” method except there are no siren
chirps emitted after you disarm.
Press trans-
mitter Button-2 then release. The doors will then
unlock and vehicle lights will flash 3 times (if so installed).
The system is now disarmed, and you may enter the vehicle
without triggering the siren.
0USHå"UTTON
NOTE:
The “No-Chirp” disarming method only silences confirmation
chirps from the external siren, not the internal piezo of the Alarm Unit.
Summary of Contents for Vision 1014C
