Kiramek Vision 1014C, Instruction Manual

Page: 28 / 40

VISION 1014C INSTRUCTION MANUAL
25
FEATURE PROGRAMMING
To program features, have your vehicle’s key ready to turn the
ignition (IG) “on-and-off” several times. ( TIP: Use the “ACC” posi-
tion as IG “off” because its easier to switch.) Perform the following
3-step procedure to alter the features shown in Table-1 below:
Disarm
1.
the system.
(Or “Arm-then-Disarm” if repeating this procedure.)
Turn
2.
IG on-and-off the same number of times as the feature you wish to
program
(refer to “No.” in
Table-1
below), within 20 sec. of disarming .
(For example, if you want to change “Auto Arm,” you must turn the IG
on-and-off 8 times within 20 sec.)
Push 3. Button-1 on the transmitter. (Your chosen setting has toggled.
The Status LED will then flash the same number of times as the feature
you just programmed.)
When the Status LED stops flashing in Step-3 above, you may program
•
another feature by restarting this procedure at Step-1.
NOTES:
(1) After you program a feature, the Status LED will flash the same
number of times as the feature you just programmed, but there will be no in-
dication of the “setting” you just toggled to—
simply test your 1014 system to
confirm your programming. (2) There is no “reset to factory default” feature.
TABLE-1 Feature Selection Menu
No. Feature Description Toggle Settings
3 IG Protect Mode / Remote Start C. Mode
IG Protect
RSCM
4 Vehicle Lights ON During Remote Start
OFF
ON
8 Auto Arm
OFF
ON
9 Exit Delay Time Selection
3 sec.
15 min.
10 Auto Rearm
OFF
ON
13 IIP Trigger Selection
All
Door
17 Exterior Illumination
OFF
ON
20 Transmitter Learning / Force Reset Code
Default Reset Code = 6
FACTORY DEFAULT SETTINGS SHOWN IN BOLD TEXT ABOVE