Kiramek Vision 1014C, Instruction Manual

Page: 16 / 40

13
MOUNTING SYSTEM COMPONENTS
The Status LED is used as a visual theft deterrent when the system is
armed. It also is used to alert you if the siren went off while you were away
from the vehicle.
You can mount the Status LED in any location you like, but keep in mind
that the wire harness is only 150cm (5ft.) long. A recommended mounting
location would be near the door window on the driver’s side where it can be
easily seen (e.g., placed on a switch blank ). Use the affixed 2-sided tape to
mount and run the wires out of view.
Status LED
The shock sensor is not waterproof so only mount it inside the vehicle , pref-
erably in a concealed location under the dash. Use the affixed double-sided
tape or screws and mount the shock sensor to the outside of an air duct, to
the inside of a trim panel, or use wire ties to secure it to large wiring har-
ness under the dash. Avoid mounting the shock sensor to the metal body
of the car or on the steering column because sensitivity may become poor.
Test the sensor in your preferred mounting location prior to affixing it with
the included 2-sided tape.
Shock Sensor
IMPORTANT!
Always mount the included 318-052 shock sensor more
than 30cm (1ft.) away from the main body of the included 318-04 Ultra-
sonic Sensor. Failure to do so may cause the shock sensor to randomly
false trigger the siren.
INSTALLATION