Kiramek Vision 1014C, Instruction Manual

Page: 30 / 40

27
PROGRAM FEATURES EXPL AINED
This feature automatically rearms the system 60 seconds after it is dis-
armed, unless a door is opened or the Ignition goes on during the 60 sec-
onds. Doors will be locked when the system rearms, if so installed. Note
that this feature is incompatible with vehicles that automatically illuminate
the dome light upon door unlock, unless the 1014’s door input is wired di-
rectly to the “door switch” (and not wired to “door dome light switch”). The
reason is that the system will not rearm if it sees “a door open” condition.
10 Auto Rearm
When Remote Start Compatibility Mode is ON , you may select which “trig-
ger sectors” IIP uses to temporarily switch the system back into IG Protect
Mode while IG is off. You have two programming choices:
(1) ALL:
switch
to IG Protect Mode upon sensing a door open condition
and/or
a sensor
trigger; or
(2) DOOR:
switch to IG Protect Mode upon sensing
only
a door
open condition.
Here is how IIP responds when set to “
ALL
”:
If a door is opened and/or if a sensor was triggered
•
, the system will au-
tomatically switch to IG Protect Mode and trigger the siren, and turning
on IG will continue to trigger the siren up to 7 times (30 sec. each time).
IIP will then automatically switch back to Remote Start Compatibility
Mode when the system is disarmed by the remote.
Here is how IIP responds when set to “
DOOR
”:
If a door is opened
•
, the system will automatically switch to IG Protect
Mode and trigger the siren, and turning on IG will continue to trigger
the siren up to 7 times (30 sec. each time). IIP will then automatically
switch back to Remote Start Compatibility Mode when the system is
disarmed by the remote.
If only a sensor was triggered (no door opened)
•
, and later if the ignition
goes on, the siren will
not
go off and the shock sensor will be bypassed in
accordance with normal “Remote Start Compatibility Mode” functional-
ity (as described on page 23) .
13 IIP Trigger Selection
OPERATION