Kingfisher KI 2300 Series, Operation And Maintenance Manual

Page: 70 / 74

QUICK REFERENCE GUIDE: LIGHT SOURCE
KI2000 UM-6
-
68 -
KI2400/KI2800 HAND HELD FIBER SOURCE,
KI2300/KI2700 LOSS TEST METER
Manual operation

To remove interchangeable connector adaptor, press button
on front of case and pull off adaptor. This may be easier with
a test lead attached.

To turn on press [On/Off]

To defeat auto power-off , hold [On/Off] for 3 seconds at turn
on until ‘Perm’ is displayed.

Low battery is indicated with a battery symbol.

To enter Source menu, press [Source]

To return to Home menu, press [Home]

To turn on back light press [ Backlight]
Source Menu:

Press [ - ] or [ + ] to select operating wavelength.

To change power level, press [F2] then use [ - ] or [ + ] (laser
light source only, not available for LED sources)

To restore default power level, press [F2] then press
[Toggle centre] (laser light source only, not available for LED
sources)

To select modulation while source is on, press and release
[Mode]. Press [Mode] again to select next available
frequency or ID-tone. Alternatively, press and hold [Mode]
then use [ - ] or [ + ] to cycle through all options.

To end modulation, press and hold [Mode] then press
[Toggle centre]. Alternatively, press and hold [Mode] for 3
sec.
Autotest Operation

To start Autotest, press [AUTO].

To check wavelength status, eg if it is selected for limited
wavelength AutoTest, press [F4] while source is on.

To toggle selection of wavelengths for limited wavelength
AutoTest, press and hold [Toggle centre] then press [F4]
while source is on.
To start limited wavelength AutoTest, press and hold
[Toggle centre], then press [Auto].