38
If auxiliary heating lies in direct control mode, the figure located at top left corner show surplus minute
number, the symbol such as “AUTO”,“ON”and “OFF”appear on display screen.
Select the auxiliary heating state, such as ON, OFF and AUTO by TEMP rotary knob in driver zone, choose
by TEMP rotary knob in passenger zone from following values, “25”, “50”, “75”, “100” and “120”,
corresponding to auxiliary heating running time: minute. If choose“120”, auxiliary heating will run for 2
hours after the engine stop starting.
AUTO: when engine water temperature is less than 71 centigrade, or exterior temperature is less than
17 centigrade, and or exterior temperature sensor breaks down, in that case, initiate auxiliary heating.
ON: when auxiliary heating being turn on, selected time indicated on right side display screen, once
take the time, auxiliary heating will keep “AUTO” location. If choose “120”, the auxiliary heating will
run for 2 hours after the engine stop starting.
OFF: auxiliary heating will turn off.
Press for a short time auxiliary heating key
, exit from programming interface.
If choose a definite run time, thus, pure black flame icon appears on display screen, meanwhile, fuel heater
will be activated.
If the fuel heater runs in automatic mode, thus, no icon appear on display screen. When press down AUTO
keys in driver zone and in passenger zone, then the time value set in ON mode will be eliminated, and
change into AUTO mode.
15
VENT setting
key in passenger
zone
－
VENT outlet is closed
and not changed.
Inlet air mode in passenger zone could be changed by pressing the
key, inlet air mode indicates on display screen.
When the mode of defrosting\dehumidification opened, inlet air
mode in passenger zone will not be adjusted by manual style,
because the air inlet is opened in defrosting mode.
If inlet air mode in passenger zone was adjusted by manual style,
automatic mode in passenger zone will void and change into
manual mode.
