Kilsen KFP-AE1(-S), Installation Manual

Page: 77 / 148

Chapter 3: Configuration and commissioning
KFP-A Series Installation Manual 71
General configuration
Select General configuration to configure the DACT status (used or not used)
and event reporting settings. Configuration options are shown in the table below.
Table 32: General DACT configuration options
Option
Description Default value
Used Configures the DACT status (used or not used) Not used
FR_ERM [1] Configures the event reporting mode for all configured
central monitoring stations: Fire Routing mode (for alarm
event transmission) if checked or Event Reporting mode if
not checked
Event Reporting
mode
[1] If checked, alarm events are transmitted when the fire routing group is activated and after any
configured activation delay. If the transmission fails, a fire routing acknowledgement fault is
indicated.
To change the configuration:
1. Select Panel setup from the Main menu.
2. Select DACT config, and then select General config.
3. Select and check the check box for the options that you want to enable.
4. Press F4 (Enter), and then press F1 (Back).
5. Press F1 (Save), F3 (Apply), F4 (Discard), or F2 (Exit).
Remember to apply saved settings from the Main menu.
Ethernet configuration
Select Ethernet configuration to configure settings for monitoring network
communication with the central monitoring station (CMS). Configuration options
are shown in the table below.
Table 33: Ethernet configuration options
Option
Description Default value
Period Configures the heartbeat period (in seconds) 3
Fails Configures the minimum number of consecutive heartbeat
failures required to indicate a communication error with the
central monitoring station
3
To change the configuration:
1. Select Panel setup from the Main menu.
2. Select DACT config, and then select Ethernet config.
3. Select Period, and then enter the value in seconds (1 to 99).
4. Select Fails, and then enter the value (1 to 10).