Kilsen KFP-AE1(-S), Installation Manual

Page: 117 / 148

Chapter 4: Maintenance
KFP-A Series Installation Manual 111
Battery maintenance
The control panel requires two 12 V, rechargeable, sealed lead-acid batteries
with 7.2, 12, or 18 Ah capacity. Compatible batteries for this product are shown in
Table 64 below.
Batteries are located inside the control panel cabinet and must be installed in
series. Polarity must be observed. Connect batteries to the BAT connector on the
control panel PCB.
Table 64: Compatible batteries
Battery type
Recommended batteries
12 V, 7.2 Ah UTCFS BS127N
Fiamm FG20721/2
Yuasa NP7-12
12 V, 12 Ah UTCFS BS130N
Fiamm FG21201/2
Yuasa NP12-12
12 V, 18 Ah UTCFS BS131N
Fiamm FG21703
Yuasa NP17-12
Battery test fault indications
A flashing Supply Fault LED indicates a battery fault or a battery cable fault.
Additional information for the fault is displayed on the LCD, as shown below.
Table 65: Battery fault messages
LCD message
Description
Battery high resistance FLT The batteries may be damaged or fully discharged
Battery fault The batteries may be damaged
Battery disconnected The batteries are disconnected or no batteries are installed
Battery short circuit There is a battery cable short circuit
If the control panel reports any of the above battery faults, check the battery
cables. If the cables are in good condition and all connections are correct, then
the batteries should be replaced immediately.
In addition to the above, the following battery charger faults may display:
• Battery charger: sensor HI
• Battery charger: sensor LO
• Battery charger: overvoltage
• Battery charger: undervoltage
• Battery charger: compensation