Kilsen KFP-AE1(-S), Installation Manual

Page: 129 / 148

KFP-A Series Installation Manual 123
Appendix A
Default configurations
The following table shows the settings for the default configuration of your panel.
Table 66: Default configurations
Description
Default setting
Power supply operation 230 VAC
Control panel ID 01
Day/night mode Full day to day mode
Control panel network operation Stand-alone
Network global commands Yes
Network mask 0 (all panels excluded from the mask)
Repeater panel network operation Repeater
Repeater mask
All panels repeated
IP address 192.168.104.140
Subnet mask 255.255.255.0
Gateway 0.0.0.0
Port 2505
24V auxiliary Not deactivated during reset, not deactivated when running
on batteries
Fault mask All faults are reported
Sounders re-sound Sounders re-sound
Expansion boards for repeater
panels
Network board is configured
Initial zone 1
Autosetup zone All detectors, manual call points, and zone modules to the
initial zone
All sounders to output group 1 (sounders)
All relay/non-supervised outputs to output group 301
(program)
All extinguishing modules to output group 801
(extinguishing)
All inputs configured as technical alarm latched