38
WireWorks
®
Panel System
Assembly Instructions
Assemble units as described herein only. To do otherwise
may result in instability. All screws, nuts and bolts must be
tightened securely and must be checked periodically after
assembly. Failure to assemble properly, or to secure parts
may result in assembly failure and personal injury.
Installing End-Of-Run Trim
End-of-run trim is installed over
the exposed portion of a full post
in an end-of-run condition and is
the same height as a panel.
Note:
Each end-of-run includes
a to cap and two base raceway
caps.
1. Install left- and right-hand base
raceway caps into the end of
the door of the base raceway
(Detail P). The purpose of the cap
is to fill in the gap between the
end of the base raceway and the
end-of-run trim.
2. Install end-of-run top cap into
the end-of-run trim. A “To Floor”
note is molded into the inside of
the top cap.
3. Push the end-of-run trim with
top cap onto the full post. Ensure
that the notch at the bottom of the
trim rests on the lip of the glide
housing (Figure 60).
Installing Universal Corner
Trim
90° corner and 3-way
intersections use universal trim
to finish the corner. A 90° corner
uses two pieces of universal trim
and a 3-way intersection uses
one piece.
1. Position the universal corner trim
over each corner connector and
firmly snap it into place
(Figure 61).
Note:
To remove universal trim
from corner connectors, remove
the top cap from the horizontal
rail, slide the universal trim up
approximately 18” past the corner
connector and twist to detach
(Detail Q).
Summary of Contents for WireWorks
Page 1: ...Assembly Instructions WireWorks Panel System January 2020...
Page 2: ...A...
Page 46: ...44...
Page 47: ...45...