KI WireWorks, Assembly Instructions Manual

Page: 7 / 48

WireWorks
®
Panel System
Assembly Instructions
Assemble units as described herein only. To do otherwise
may result in instability. All screws, nuts and bolts must be
tightened securely and must be checked periodically after
assembly. Failure to assemble properly, or to secure parts
may result in assembly failure and personal injury.
5
Highest Point of Floor
Prior to erecting the system,
locate the highest point of the
floor and position the first corner
of the workstation at that point.
Assembling Intersections
Note: Refer to the
space-planning layout to
determine the necessary
intersection specifications.
1. Assemble intersections by
bolting two, three, or four half
posts together using a connector
block, shoulder bolts and
washers with a
3
/
16
” allen wrench
(Figure 1). Refer to page 7 for
the correct number of connector
blocks per intersection.
Note: The plastic inserts at
the bottom of the vertical posts
must be oriented such that the
recessed cut out is positioned
under the slots (Detail A).
Note: All half posts get one
connector block in the lowest
hole and one connector block in
the highest hole, with taller posts
requiring additional connectors.
See Planning Guide for more
detailed information. Position
connector blocks at heights that
avoid obstructing power and data
cabling. Refer to the
space-planning layout for power
and data locations.