WireWorks
®
Panel System
Assembly Instructions
Assemble units as described herein only. To do otherwise
may result in instability. All screws, nuts and bolts must be
tightened securely and must be checked periodically after
assembly. Failure to assemble properly, or to secure parts
may result in assembly failure and personal injury.
23
Installing Top Power Infeed
WARNING:
Assembly of all
mechanical frame components
must be completed before
making any electrical
connections. All electrically
connected furnishings must also
be mechanically connected.
Note:
The panel being used as
the top infeed panel must be in
its final position in the room.
The top infeed consists of four
parts: the power pole, the top
infeed panel, panel trim and
ceiling trim. The power pole
and trim pieces are designed so
they can be easily installed after
power and data are run into the
panel.
1. Orient the top infeed harness
so the
N
symbol points up.
Attach the harness to the rigid
wireway the same way you attach
a jumper (See page 16).
2. Feed the hardwire end of the top
infeed harness up through the
notches in the horizontal rails
(Figure 33).
3. Proceed to installing the power
pole and trim (See page 24).
Summary of Contents for WireWorks
Page 1: ...Assembly Instructions WireWorks Panel System January 2020...
Page 2: ...A...
Page 46: ...44...
Page 47: ...45...
