WireWorks
®
Panel System
Assembly Instructions
Assemble units as described herein only. To do otherwise
may result in instability. All screws, nuts and bolts must be
tightened securely and must be checked periodically after
assembly. Failure to assemble properly, or to secure parts
may result in assembly failure and personal injury.
39
Installing Universal Height
Change Trim
Height change trim is the same as
universal trim with a small notch
in the bottom. These trim pieces
are used to fill in between panels
of two different heights.
1. Orient the notch downward and
snap the trim over the exposed
portions of the connector
block (Figure 62).
Note:
Face the opening of all
height change connector blocks
toward the shortest panel to
allow for lay-in wire management
(Detail R).
Installing 3-Way and 4-Way
Light Block Tubes
In 3-way and 4-way intersection
conditions, light block tubes are
required.
1. Slide the light block tube through
the holes in the center of
connector block (Figure 63).
Note:
If necessary, the tube may
be collapsed and bent where there
is not enough ceiling clearance
to slide the tube vertically into
position.
Hint:
The light block tube is held
in place by friction. If the tube
does not stay positioned, use a
wrap of black electricians’ tape
around the tube above one of the
connector blocks.
Summary of Contents for WireWorks
Page 1: ...Assembly Instructions WireWorks Panel System January 2020...
Page 2: ...A...
Page 46: ...44...
Page 47: ...45...