1. In the address bar, type
about:config
and press
Enter
.
2. Click
"I'll be careful, I promise"
.
3. In the search bar, search for
javascript.enabled
.
4. Right click the result named
javascript.enabled
and click
Toggle
. JavaScript is now turned off.
To turn on JavaScript, repeat these steps.
To turn on JavaScript for Safari, do the following:
1. Open a Safari browser window.
2. Click
Preferences
from the Safari menu.
3. Click
Security
from the top of the window.
4. Click
Enable JavaScript
located under the Web Content section.
5. Close the
Security
window.
You must also have the host address that has been set for the BPS management port and the
BreakingPoint Control Center login information.
Note:
The chassis must already be installed and configured before the BreakingPoint Control
Center can be accessed. For more information on installing and configuring your BreakingPoint
device, see your BreakingPoint device’s installation guide.
Browser Resources
If you have several browser windows open simultaneously, or if you have multiple instances of the
BreakingPoint Control Center open, this may cause lagging or delayed responses from the computer.
This is normal behavior for the BreakingPoint Control Center if multiple browser resources are being
used.
Note:
We recommend clearing your cache and refreshing your browser after upgrading or
reverting to any release of BreakingPoint.
Navigational Overview
This section provides an overview of the navigational areas in the BreakingPoint Control Center. The
BreakingPoint Control Center is divided into two main areas: the BreakingPoint Control Center menu
bar and the navigational buttons. See the following image for a tour of the interface:
Chapter 3 Getting Started
– 14 –
