Keysight Infiniium 8000 Series, Service Manual

Page: 25 / 162

Chapter 2: Preparing for Use
To connect the standard 10073C probes
25
To connect the standard 10073C probes
1
Attach the probe connector to the desired oscilloscope channel or trigger input.
Rotate the BNC connector until it slides on easily and push it straight on. Rotate
the locking ring until it latches into place.
Figure 2-5
Attaching the Probe Connector
2
Connect the probe to the circuit of interest using the browser or other probing
accessories.
3
To disconnect the probe, rotate the locking ring counterclockwise so it unlocks,
then pull the BNC connector body away from the front panel of the oscilloscope.
C A U T I O N Do not exceed the maximum input voltage rating. The maximum input voltage for 8000
Series oscilloscopes 50
Ω
inputs is 5 Vrms, CAT I. Maximum voltage at 1 M
Ω
impedance
is ±100 V (DC + AC) [AC < 10 kHz], CAT I.
!