Keysight Infiniium 8000 Series, Service Manual

Page: 117 / 162

Chapter 6: Replacing Assemblies
To remove and replace the PCI bridge board
117
To remove and replace the PCI bridge board
Use this procedure to remove and replace the PCI bridge board. When necessary, refer
to other removal procedures. The graphics in this chapter are representative of the
oscilloscope at the time of this printing. Your unit may look different.
1
Disconnect the power cable and remove the top cover.
2
Remove the keyboard cable and the acquisition board cable from the PCI bridge
board.
3
Remove the two Torx T10 screws that secure the PCI bracket assembly to the
chassis.
Figure 6-23