Keysight Technologies FieldFox A Series, User Manual

Page: 92 / 756

92 Keysight N9927-90001 User’s Guide
NA (Network Analyzer) Mode
NA Mode Settings
How to select a multi-trace configuration
— Press Trace 6
— Then Num of Traces
— Then choose from the following:
The default measurements depend on the options that are installed
How to activate a trace in order to change a setting
— Use the arrows OR
— Press Trace 6 then select Trace 1 , Trace 2 , Trace 3 , or Trace 4 , Only traces
that are shown can be activated.
How to maximize the viewing of the active trace
— Press System 7
— Then Full Screen .
— Press any key to return to the standard display.
Quick Settings
Both CAT and NA Modes allow you to view and change most relevant settings
from a single location. All of these settings are discussed in this chapter and,
unless otherwise noted, ALL of these settings can also be made using the
standard softkey menus.
x1
1 trace standard configuration
x2
2 traces overlayed on a single graticule
x2H
2 traces on separate graticules
x3H
3 traces on separate graticules
x3
3 traces overlayed on a single graticule
x4
4 traces overlayed on a single graticule
x4H
4 traces on separate graticules