Keysight Technologies FieldFox A Series, User Manual

Page: 346 / 756

346 Keysight N9927-90001 User’s Guide
5G Rapid Prototype Phased Array Antenna – Option 360
How to Set Up Phased Array Antenna Settings
— Clear Graphics If applicable, this clears the current displayed PNG
graphic from the screen.
7. User markers to identify azimuth and elevations settings:
Select
Marker –choose:
— Marker 1 2 3 4 5 6 – You can set up to six markers. The OFF,
Normal, Delta, or Peak softkey is black to indicate the current setting
of each marker .
— Normal displays a marker.
— Delta displays a marker relative to another active marker.
— Peak displays a marker on the peak point of the displayed trace.
— More – choose.
— Marker Trace – You can set up to four traces.
— Marker Table – Enable or disable the marker table that displays the
current markers and their values.
Learn more about markers. Refer to the Chapter 28, “Data Analysis
Features.” .
See also Figure 5 on page 336 .
8. Enable the Data Logging settings:
— Press Measure 1
— To set Data Logging —choose:
— Record or
— Play or
— Save Recall Rec-Playback (If you have previously stored
data recordings.)
—— Save Log File or
—— Recall Logs or
—— User Folder Def System (Default = Default) or
—— File Type (Default = KML) CVS or DREC
If after making the setting changes in the steps below, no data is
displayed, refer to “Troubleshooting” on page 364 .
Spectrum information is not recorded. Only the TableChart data are saved.
See “How to Record” on page 360 .