Keysight Technologies FieldFox A Series, User Manual

Page: 211 / 756

Keysight N9927-90001 User’s Guide 211
SA (Spectrum Analyzer) Mode
How to Set Up EMF Settings (Requires EMF (Option 358), GPS (Option 307), and SA
Mode (Option 233–Mixed Analyzers))
— Default Receiver side only antenna measurements.
— Src/Rcvr Split to work with non-triaxial receiver
and source side antenna measurements.
— Triaxial XYZ (default, when Channel Power is on and
when a compatible triaxial antenna’s factors have
been imported) for measuring channel
measurements and EMF.
— Then Back to exit to the previous softkey menu.
e. Optional :
Verifying antenna and cable corrections are applied:
i. Press Scale/Amptd > Corrections > Apply Corrections OFF
ON
Verify the Apply Corrections softkey is set to ON (This is the
default setting when a compatible USB antenna’s correction
factors have been imported, via the System softkeys).
Verify the
X axis Antenna , Y axis Antenna , and Z axis Antenna
are all ON . These can each be enabled or disabled
individually, but for EMF measurements all three axes should
be enabled (i.e., Antenna = Off, the applications are setting
the X/Y/Z).
Verify
Cable is ON . This can be disabled for applications
where an additional cable has not been connected to the
triaxial antenna. Before a cable can be used with the EMF
measurements it needs to have corrections loaded. If you are
going to use a cable, then choose as needed:
— Cable Off to open the cable correction softkeys menu
— Edit Cable displays a cable corrections table
that you can edit
— New displays a cable corrections table that
you can edit with new cable correction
content.
—— Choose Yes to overwrite the current
cable data
—— Choose No to exit the cable data
edit table view
— Save Cable Opens a menu to name and save
the cable corrections data
— Recall Cable Recalls the selected cable
correction file from the
\Cables
folder.