Keysight Technologies DSO-X 2002A, User Manual

Page: 174 / 352

174 Keysight InfiniiVision 2000 X-Series Oscilloscopes User's Guide
13
Cursors
You can press the X Units softkey to select:
• Seconds (s) .
• Hz (1/s) .
• Phase (°) — when selected, use the Use X Cursors softkey to set the current X1
location as 0 degrees and the current X2 location as 360 degrees.
• Ratio (%) — when selected, use the Use X Cursors softkey to set the current X1
location as 0% and the current X2 location as 100%.
You can press the Y Units softkey to select:
• Base — the same units used for the source waveform.
• Ratio (%) — when selected, use the Use Y Cursors softkey to set the current Y1
location as 0% and the current Y2 location as 100%.
For phase or ratio units, once the 0 and 360 degree or 0 and 100% locations are
set, adjusting cursors will display measurements relative to the set locations.
7 Adjust the selected cursor(s) by turning the Cursors knob.