48
1130B-Series Probes User’s Guide
2
Using Probe Heads
melts, the lead wire will fall into the hole. Remove soldering iron as soon as the
lead wire falls into the hole..
4
Apply flux on the solder joint, Then apply a small amount of solder to the tip of
the soldering iron. Touch the solder tip (with the solder on it) to the solder joint.
Do not dwell on the joint with the solder iron any longer than needed. The
solder should flow off the soldering iron tip into the joint. If it does not flow, then
sufficient flux may not have been used.
5
Cut the extra wire off using a cutting tweezer (Keysight part number 8710-2838
included in the MX0102A Soldering Toolkit).
6
Remove the Kapton tape.
Summary of Contents for 1130B Series
