Keysight Technologies 1130B Series, User Manual

Page: 47 / 234

Using Probe Heads
2
1130B-Series Probes User’s Guide 47
1
Secure the tip of the MX0100A probe head on a raised off position from the
table. You may use a double-sided foam tape (Keysight part number
0460-3122 included in the MX0102A Soldering Toolkit). Keep the lead wires
solder joints off the raised base to facilitate soldering. Cover the entire probe
head tip with Kapton tape while ensuring that the lead wires solder joints are
fully exposed for soldering.
2
Remove the damaged lead wire from the via by grabbing it with tweezers and
pulling up very gently. Touch the soldering iron to the solder joint just long
enough for the lead wire to come free of the probe head tip.
3
Position the end of the new lead wire (Keysight part number MX0102-21302 or
MX0102-21303 included in the MX0102A Soldering Toolkit) over the via hole.
Touch the soldering iron to the side of the hole. When the solder in the hole
Low Temperature Solder Wire (lead
free)
Requires a low temperature setting on
your soldering iron.
(NOTE: This alloy melts at 138
o
C.)
.010" diameter MX0102-21303
CAUTION
To avoid burning and damage to the probe head, do not keep the
soldering iron in contact with the tip any longer than necessary.
The solder joint quickly melts and releases the wire.
Table 10 Required Wire Types
Wire Type Wire Diameter Part Number