38
Betrieb / Operation / Provoz / Praca
Signal
Meldung
Erforderliche Maßnahmen
Licht blinkt
schnell grün
Endlagenabgleich erfor-
derlich
Führen Sie einen Endlagenabgleich durch.
5.5
System Information
The system information is communicated via flashes of the LED Signal Light on the hand switch.
Possible signals are as follows:
Signal
Message
Required Actions
No Light
System operating normally
System not connected
Operate the LifeUP Pro System as normal.
See configuration on page 21, picture 9.
Red Light
Blinking
System Error Warning
Release all keys and wait for 5 seconds. Then,
try to repeat the action again.
Disconnect all components from the Power
Hub. Disconnect the Power Hub from the
Mains. Check the Power Hub for overheating.
Let cool if necessary.
Check all connections and reconnect the
system.
If problem persists: Perform a Position Reset
Procedure (Chapter 5.1). Contact
Kesseböhmer
Green Light
Blinking
System Start-up
Reset in Progress
Duty Cycle Exceeded
Wait until the LED has stopped blinking to
continue.
Do not press any buttons.
Remove the obstruction from the Table Sys-
tem.
Remove unnecessary loads from the Table Top
Operate the LifeUP Pro System as normal.
f
Betreiben Sie das
LifeUP Pro-
System nicht, wenn die Probleme weiterhin
bestehen. Kontaktieren Sie
Kesseböhmer
für weitere Informationen.
Hinweis
Summary of Contents for 873 330 904
Page 16: ...16 Montage Assembly Montáž Montaż 3 m i n 2 0 m m m a x 8 0 0 m m ø5 x 25 8x 1200mm 4 ...
Page 21: ...21 Montage Assembly Montáž Montaż 10 11 ø5 x 25 8x 12x ø5 x 60 optional volitelný opcjonalny ...
Page 22: ...22 Montage Assembly Montáž Montaż 4x 12 12 1x 4x ø4 x 16 1x ø4 x 16 ...
Page 55: ...55 Notizen Notes Poznámky Notatki 11 Notizen Notes Poznámky Notatki ...