Kenwood NEXEDGE NX-200, Service Manual

Page: 88 / 172

NX-200
88
ADJUSTMENT
Item
Condition Measurement Adjustment
Specifi cations /
Remarks
Panel tuning mode PC test mode
Test-
equipment
Unit Terminal Unit Parts Method
4. Clockwise
Volume
1) Adj item: [VOL2]
Adjust:
[
✳✳✳
]
1) Adj item: [Clock-
wise Volume]
Panel [Panel tuning mode]
Turn the volume
knob clockwise
fully.
Press [ ] key to
store the adjust-
ment value.
[PC test mode]
Turn the volume
knob clockwise
fully.
Press [Apply] but-
ton to store the
adjustment value.
This item is needed
when the variable
resistor (R31-0666-
05) is replaced.
5. Receive
Assist
1) Adj item: [RAST]
Adjust:
[
✳✳✳✳
]
2) Adj item:
[L
RAST] →
[L’ RAST] →
[C RAST] →
[H’ RAST] →
[H RAST]
Adjust: [
✳✳✳✳
]
Press [ ] key to
store the adjust-
ment value.
1) Adj item:
[Receive Assist]
2) Adj item: [Low],
[Low’],
[Center],
[High’], [High]
Press [Apply All]
button to store the
adjustment
value.
[Panel
tuning
mode]
[ ],
[ ]
[PC test
mode]
[ ],[ ]
The sub LCD display
and [V] indicator
on the PC window
shows VCO lock
voltage. Change the
adjustment value
to get VCO lock
voltage within the
limit of the speci-
fi ed voltage.
Note:
Confi rm the VCO
lock voltage approxi-
mately 3 seconds
after the adjustment
value is changed.
2.5V±0.1V
[PC test mode]
Press [Apply All]
button to store the
adjustment value
after all adjustment
point was adjusted.
Transmit
Assist 1) Adj item: [TAST]
Adjust:
[
✳✳✳✳
]
2) Adj item:
[L
TAST] →
[L’ TAST] →
[C TAST] →
[H’ TAST] →
[H TAST]
Adjust: [
✳✳✳✳
]
PTT : ON (RF power
is not output.)
Press [ ] key to
store the adjust-
ment value.
1) Adj item:
[Transmit Assist]
2) Adj item: [Low],
[Low’],
[Center],
[High’], [High]
PTT: Press
[Transmit] button.
Press [Apply All]
button to store the
adjustment
value.
6. RTC
oscillation
frequency
adjust
1) Adj item: [RTC]
Adjust:
[
✳✳✳
]
1) Adj item: [RTC
(Real-time
clock)]
[Side1] [Panel tuning mode]
Press [Side1] key.
After automatic ad-
justment adjusted
value is displayed
on the LCD.
Press [ ] key to
store the adjust-
ment value.
[PC test mode]
Press [Start] button
of “Auto Tuning”.
Press [Apply] button
to store the adjust-
ment value after the
automatic adjust-
ment was fi nished.