Kenwood DNX4150BT, Quick Start Manual

Page: 129 / 211

96 96
Return to the Top page
Setting Up
Security setup
A red indicator will blink on the unit after the
ACC is set to OFF, warning potential thieves.
If turned to “ON” (default), the security
indicator on the front panel flashes when the
vehicle ignition is off.
1
Touch [Security] in the System Menu
screen.
Security screen appears.
2
Touch [ON] or [OFF] of [SI].
EXT SW setup (DNX892,
DNX7150BT)
Set up the external switch power mode.
1
Touch [EXT SW] in the System Menu
screen.
EXT SW screen appears.
2
Set each item as follows.
SW Name
Sets the name of the external device.
Output Pattern
Sets the power signal output mode among
“Pulse”/“Level”. Default is “Pulse”.
Pulse Set
Sets the pulse signal output time.
Outputs 500ms when “1” is set.
Increases by 200ms with each step. Up to 100
steps can be set.
NOTE
• You can enter characters only after you have
applied the parking brake.
• “Pulse”: Generates a single power signal pulse.
• “Level”: Continues output of high power signal.
External Device Control
Control the external device power supply.
1
Press the <MENU> button.
Popup menu appears.
2
Touch [ ].
You can turn on or off the external device
power supply.
NOTE
• You must connect a commercially available relay
unit in order to use this function. Connect the
external device to be controlled to that relay unit.