Kenmore 795.78733.806, Service Manual

Page: 33 / 83

- 33 -
6-6-4 Function TEST
1. This is a forced operation for TEST, Service, cleaning, etc. It is operated by pressing and holding the Fill Key for 3
seconds.
2. The test works only in the Icemaking Mode. It cannot be entered from the Harvest or Fill mode.
3.
Caution! If the test is performed before water in the icemaker is frozen, the ejector will pass through the water. When the
Fill mode begins (Stage 4), unless the water supply has been shut off, added water will overflow into the ice bin. If the
control doesn’t operate normally in the TEST mode, check and repair as needed.
4. After water is supplied, the normal CYCLE is followed: icemaking Harvest Park Position Fill .
5. Five seconds after Stage 5 is completed, the Ice Maker returns to MICOM control. The time needed to supply water
resets to the pre- test setting.
STAGE ITEMS INDICATOR REMARKS
1 HEATER
Five seconds after heater starts, a heater will
go off if the temperature by sensor is higher
than 10°C
Diagnosis TABLE
2 MOTOR
Five seconds after heater starts, you can
confirm that a motor is moving.
3
HALL IC I
Check if Ice Bin is full or not.
If Ice bin is full, the motor and heater are off
and on stand by until Ice bin is empty.
4 HALL IC II
You can confirm HALL IC detection of start
position.
5
VALVE
Two seconds after detection of start position,
you can confirm that valve is on.
6 Reset
Five seconds after fifth stage is completed,
The icemaker resets to initial status.
Return to Status prior
to TEST MODE
NO DIVISION INDICATOR REMARKS
1 Normal
Display switch operates
properly
Mark time to supply
2
Icemaking
Sensor
malfunction
Make sure that the wire on
each sensor is connected.
CONTENTS
None
Open or short-circuited wire
6-7 DEFECT DIAGNOSIS FUNCTION
6-7-1 ERROR CODES shown on Ice Maker water supply control panel