X8 MIG WELDER
2.4 Operation
Figure 30: 1-MIG Welding view
When using 1-MIG, you can adjust the following welding parameters through
Settings
>
Parameters
:
• Wire Feed Speed
• min: adjusts the minimum set value for wire feed speed
• max: adjusts the maximum set value for wire feed speed
• Fine tuning: adjusts the voltage (arc length).
• Dynamics: -10...+10. Adjusts the short circuit behavior. On the minus side, the arc is softer (less spatter).
On the plus side, the arc is harder (the arc is more stable).
• StartPower: -30...+30. Adjusts the power level for arc ignition.
• StartLevel: -30...+30. Fine tunes the arc length for arc ignition.
• StopPower: -30...+30. Adjusts the power level for arc stop.
Pulse
%
Pulse is a synergic MIG/MAG welding process where the current is pulsed between the base current and
the pulse current. The advantages of Pulse are a higher welding speed and deposition rate compared to
short-arc welding, lower heat input compared to spray-arc welding, a spatter-free globular arc and smooth
OPERATING MANUAL | EN
121
©
KEMPPI | 2018-09-28
