Keithley Series 2200, Reference Manual, Page: 21 / 160

Series 2200 Programmable DC Power Supplies Reference Manual Section 2: General operation
2200S-901-01 Rev. C / March 2016 2-9
Configuration menus description
Use the configuration menus to configure (setup) the instrument. Sometimes the configuration menus
are called the settings menus. See the following table for information on the primary menu selections,
secondary menu selections, options, and a brief description of each selection. The following table
indicates default settings in
bold .
Primary
menu Secondary menu First option Additional
option(s) Allows you to ...
>Default Set
No
Yes Return the instrument to the factory
default configuration. See
Initializing
to the default setup (on page 2-17) for
more information.
>Protect >Reset Protect
No
Yes Reset Protect menu selections to the
factory default configuration.
>Max Volt Set Off Turn maximum output voltage setting
off.
On Max = Set or edit maximum output voltage
for the instrument. See
Setting the
maximum voltage (on page 2-18) for
more information.
>OVP Set
Off
Turn overvoltage protection (OVP)
off.
On OVP = Turn overvoltage protection on and
set or edit the voltage threshold. See
Setting the overvoltage protection (on
page 2-19) for more information.
>Out Time Set Off Turn out time mode off.
On Time = Turn out time mode on and set or edit
the time period. See
Timer example
(on page 2-30) for an example of
setting a timer with Out Time Set.
>Key Lock Password = unlock Indicates that no password is set to
lock all front panel controls except
power switch and output on/off key.
Enter up to 4 digits to set a password.
Lck Indicates that a password has been
set.
>Edit
List >Recall 1-7 Empty Recall or edit lists saved in up to 7
locations. Empty indicates no saved
list. See
Define a list of voltage and
current steps (on page 2-24) for more
information.
Continuous Repeat =
Set instrument to continuous mode. If
set, the instrument executes the
entire sequence of steps as soon as it
receives the next trigger signal.
Repeat allows you to set or edit
number of times to repeat the list.
List Steps allows you to indicate the
number of steps in the list.
See
List mode example (on page 2-
30) for a list example.
Step Repeat =
Set instrument to step mode. If set,