Keithley Series 2200, Reference Manual

Page: 22 / 160

Section 2: General operation Series 2200 Programmable DC Power Supplies Reference Manual
2-10 2200S-901-01 Rev. C / March 2016
Primary
menu Secondary menu First option Additional
option(s) Allows you to ...
the instrument will advance to each
step only after it receives a trigger
signal.
Repeat allows you to set or edit
number of steps.
List Steps allows you to indicate the
number of steps in the list.
>User >Reset User No Yes Reset User menu selections to the
factory default configuration.
>Output Recall Off Turn output recall mode off.
On Set power output state to that which
was in use before power was last
turned off. See
Recall the power
supply ON/OFF output state at power
on
(on page 2-20) for more
information.
>Save Last On Save last operating parameters in
use before turning instrument off.
Restores saved parameters when
instrument turned on. See
Recall the
power supply operating parameters at
power on
(on page 2-21) for more
information.
Off Turns save last mode off.
>Key Beep
Off
Turns off key press notification
sound.
On
Turns on key press notification
sound. See
Setting the key sound (on
page 2-21) for more information.
>Knob Lock
Off
Unlocks navigation wheel .
On Locks navigation wheel . See Lock
the navigation wheel (on page 2-22)
for more information.
>System >Reset System No Yes Reset System menu selections to the
factory default configuration.
>Port Mode Trigger Set port mode input to trigger. You
must also set the trigger source (Trig
Source).
RI/Def Set port mode input and output to
RI/Def. You must also set the remote
inhibit mode (RI mode).
Digital
Set port mode input and output to
digital. This setting is for
programmable interface commands
described in
Commands listed in
alphabetical order (on page 4-2).
>Trig Source
Manual
Set rear panel port mode to manual
trigger.
External
Set rear panel port mode to external
trigger.
Bus
Set rear panel port mode to bus
trigger.