© Copyright 2016 KE2 Therm Solutions, Inc., Washington, Missouri 63090
Q.1.35 January 2016
Page 4
therm
solutions
Energy Saving Refrigeration Controller
Adaptive
Control
.
therm
solutions
Energy Saving Refrigeration Controller
Adaptive
Control
.
therm
solutions
Energy Saving Refrigeration Controller
Adaptive
Control
.
At the entrance
On the wall
On the evaporator
1
1
Determining Location
The controller is designed to be as versatile as possible. The loca-
tion should be discussed with the end users to determine if they
have a preference. It is designed so it can be installed inside or
outside the controlled space.
The controller can also be located at the condenser, but should not
be installed outdoors without an enclosure to protect it from sun-
light and moisture (must be within operating range -40°F to 120°F)
Evaporator
?
therm
solutions
Energy Saving Refrigeration Controller
A
daptive
Control
.
Cut a length of conduit to go from the controller to the evaporator
Measure the distance between the controller and evaporator to
account for the extra length necessary to properly route conduit.
Determine the number of wires to go to the controller.
Controller power (2 wires)
Fan control (2 wires)
Defrost (heater) control (2 wires)
Liquid line solenoid (2 wires)
Note: Install in accordance with local wiring codes. KE2 Therm
does not accept responsibility for incorrect or unsafe wiring.
2
2
Cut wires to length
Once the number of wire is determined, cut the wires to length.
The wire should be long enough to account for the necessary con-
nections in the controller and evaporator.
Use the optional KE2 Wire Harness, or select different colored wires,
(blue - fan, orange - heaters, yellow - solenoid, purple - alarm). This
will simplify the installation and troubleshooting. If only a single
color is available, both ends of the wires should be labeled with a
matching number. This will save time when wiring the evaporator.
3
3
Walk-in
Under Counter
Commercial
Reach-In
KE2 Adaptive
Control
Quick Start Guide
