Kaysun Zen On 2014, Service Manual

Page: 113 / 116

Controller
Electrical Control 107
Display the set temperature. Adjust temperature via ▲ and ▼ . No display in this area if the
unit is on FAN mode.
③
Time ON indication:
During setting the Timing ON or after set the Timing ON, the LCD would display “TIME
ON”.
④
Time indication:
Normally, LCD displays the current time of the setting clock. When press this Button last
for 4 sec. the clock will flash at the frequency of 0.5 sec. By using
▲
and
▼
to set the
minute. Release the button when finish the clock setting, the time will stop flashing
automatically, which means time setting successfully.
⑤
Time OFF indication:
During setting the Timing OFF or after set the Timing OFF, the LCD would display “TIME
OFF”.
⑥
Fan speed indication:
Press SPEED to display the current wind speed. AUTO, LOW, MED and HIGH can be
elected. The default state is high fan speed for the unit without medium fan speed.
3.2.9. Operation instructions
1 AUTO operation
Switch on the power and running indicator light on indoor unit flashes.
1. Press MODE to select AUTO.
2. Adjust temp via
▲
and
▼
. Generally the range is 17
℃
~30
℃
.
3. Press ON/OFF and running indicator light on indoor unit is lightened. Air conditioner will
work on AUTO mode and fan speed is AUTO which is non adjustable. Press the ON/OFF
button again to stop the unit operation.
NOTE
In the AUTO mode, the air conditioner can logically choose the mode of COOL, FAN by
sensing the difference between the actual ambient room temperature and the set
temperature on the remote controller. If the AUTO mode is not comfortable for you , the
desired mode can be selected manually.
2 COOL/HEAT/FAN operation
1. Press MODE to select COOL, HEAT or FAN.
2. Adjust temp via
▲ and ▼ . Generally the range is 17
℃
~30
℃
.
3. Press FAN SPEED to select AUTO, LOW, MED or HIGH.
4. Press ON/OFF and running indicator light on indoor unit is
lightened. Air conditioner will work on the set mode. Stop operation via ON/OFF.
NOTE
The FAN mode cannot be used to control the temperature. While in this mode, only steps 1
、
3 and 4 may be performed.
3 DRY operation
1. Push the MODE button to select DRY.
2. Push the TEMP button to set the desired temperature from 17
℃
to 30
℃
.