www.kayomoto.us
- 22 -
cause the boots to slip on the pedal, affect riding.
13
、
Coolant liquid
The coolant absorbs excess heat from the engine and transfer to the air
through the radiator. If there is not enough liquid in the coolant tank to cool
the engine, the engine will be damaged due to overheating.Therefore, before
each use, must check the level of the coolant to ensure the normal cooling.
To protect metal parts of the cooling system from rust or corrosion because of
the coolant, the coolant should contain chemical inhibitors.The use of coolant
without added chemical inhibitors is easy to make the metal part of the
cooling system rust, hinder the cooling pipe, affect the cooling effect.
Note:
the company initially used Volkswagen Baishun coolant for this model,
with a freezing point of -25 ℃.
Danger:
the coolant is a chemical that may be harmful to humans. Please read
the manufacturer's instructions carefully when using it.
Warning:
improper use of coolant may cause damage to engines and cooling
systems.Please follow the instructions to select the coolant containing the
inhibitor.
Check of the coolant level
When checking the coolant level, follow these steps:
◆
After the motorcycle cooling off, park well the motorcycle;
◆
Rotate the water tank cover
①
, after the hot steam in the water tank overflow,
then open the water tank cover
①
, complete the disassembly;
◆
Shaking the motorcycle, check the liquid level of the coolant, which should
be below
②
;
◆
If the amount of liquid is insufficient, adding the required amount through
the hole.
Replacement of coolant
The coolant shall be replaced regularly to extend the service life of the engine.
The replacement steps are as follows:
◆
Park the motorcycle and wait for the engine to cool down.
◆
Remove the tank cover;
◆
Place a container under the drain screw
③
, which is located under the pump
cover and is used for discharging the coolant from the engine and the water
tank.
◆
Screw out the drain screw
③
;
◆
When the coolant is fully exhausted, turn the screw back.
◆
Add a small amount of coolant through the water tank hole to check whether
there is leakage in the cooling system;
◆
Add coolant to appropriate level;
◆
Start the engine, heat it for 5 minutes, then shut it off.
◆
After the engine is cooled, check the liquid level. If the level drops, add it to
the appropriate level.
Tighten the tank cover.
Danger:
to avoid burns, do not remove the water tank cover and drain screw
when the engine is hot. Operate after the engine cools down.
Danger:
if the coolant falls on the tire, it is easy to make the tire slip, thus
causing an accident.Therefore, the coolant falling into the chassis
and wheels should be cleaned. Check
the replaced coolant, iIf there are white
spots in the coolant, it means that the
aluminum-containing
part
of
the
cooling system has been corroded. If
○
1
○
2
○
3
○
2
